XBOX ONE Controller Thumbstick ( base, cap, extension) by vipdent

Last crawled date: 3 years, 4 months ago

The 8 years old likes diggin in the silicon cover while the games are loading.
( see photos).
After printing a dozen of thumbsticks cups and extensions, at different scaling ( 105%, 95%, etc) from Thingiverse, non would fit and stay. Or they would knock
on the controller. Most would not fit.
IMPORTANT: DESIGNED TO FIT WITHOUT THE EXISITING SILICONE CAP.
The purpose of this deisgn is to substitute the exisitng covers and raise it a little bit
Printed in Tronxy TPU.
0.6 nozzle
0.3 layer height
The secret for TPU is Speed - 10mm/sec !!! ( 30 minutes per stick)
Retraction 3mm at 30mm/sec speed.
6mm brim for adhesion
print one by one as when you print one next to another the retraction is not enogh.
4 versions here: 10,11,12,13mm THIS IS THE ENTRANCE diameter. The hole.
Both 12 and 11mm work for my CR10-S but I also added the 10 and 13mm, in case you have issues.


Try the 12mm first - - -