WD Remix of Titan Aero Mount for Hypercube Evolution by Wingeddonkey

Last crawled date: 3 years, 1 month ago

This was a remix I did on helicopterguru's setup.
First I cleared the area where the adjustment knob goes.
I added the second endstop mount, and routing for the wiring, as well as added permanent JST connectors. (All of my wiring is design to unplug and mount different extruder setups)
I also modded the touch sensor mount as I do not have a sensor at the moment. I made it a cable guide instead.
The cable guide on the top could be better, if I reprint this part I will design is with a slightly taller tower to ensure my cables don't droop and get in the way during movement. I also use a rubber band around it to keep the cables from wiggling during print. (considering a clamping design of sorts)
For the ducting I also added some internal chamfers to improve printing without supports.
UPDATES: I added the newest version I created, as Im about to abandon it for something newer.
-JST Connector Slots
-Internal Wire routing
-External Clips for non wired components
-Cable Drag Chain Mount
-BL Touch and Thermistor Input Auxiliary ports on BL Touch mount
Overall, it required a lot of supports, and the internal wiring was tedious. I am leaving this here, but the work involved IMO is too much to use again.
(Printed in ABS which always comes out a bit sloppy for me compared to PLA)