Trinket Micro Controller Case by Edtharan

Last crawled date: 3 years ago

This is a housing case for the Adafruit Trinket Arduino compatible micro controller (Trinket board not included).
The features of this are
1) Small: It is not much bigger than the micro controller itself
2) Easy Snap in and out: The micro controller board snaps in and out easily, allowing you access to the board for soldering.
3) Reset button: The Trinket needs the reset button pressed to upload your program to it, the case has a button that you can press to reset without having to open the case up.
4) Trenches: There are small trenches below the pin holes that give space for solder joints to sit.
5) Side ports: To allow wires or header pins to exit the case.