ReSpeaker by Bettman

...bender-respeaker v1 grabcad bender-respeaker v1

...studio evaluation; jack 3,5mm,usb micro; interface: usb manufacturer symbol: respeaker usb mic array tme symbol: seeed-107990193

...ard) by robolab19 thingiverse the raspberry pi 4 case to fit the respeaker board (4-mic array). designed for my robodog project.

...e case for the respeaker core v2.0 board. see also my blog post about it. additional material: 4x m3*8 screws to mount the board.

... sturi2011 thingiverse case for rhasspy pi zero wit respeaker 2 mic array and a small speaker. fits in the hole from other dots.

...i. i made this model to be used as a dummy when creating cases for the raspberry pi in conjunction with this microphone gpio hat.

...valuation. the board allows some flexibility for customization upon request. http://wiki.seeedstudio.com/respeaker_mic_array_v2.0

... peripherals such as the emmc, connectors, and wireless connectivity components. http://wiki.seeedstudio.com/respeaker_core_v2.0/

...rhasspy voice assistant rhasspy is an offline voice assistant similar to the finished snips. this case is for the...

...spberrypi zero , respeaker 2 , speaker , grove temperature sensor , grove oled screen 0.96 , grove relay. seeed studio seedstudio

...e case for the respeaker core v2.0 board. see also my blog post about it. additional material: 4x m3*8 screws to mount the board.

...ard) by robolab19 thingiverse the raspberry pi 4 case to fit the respeaker board (4-mic array). designed for my robodog project.

... sturi2011 thingiverse case for rhasspy pi zero wit respeaker 2 mic array and a small speaker. fits in the hole from other dots.

...eaker cable of 3w-speaker ist cut and soldered again, but this is not necessary. this case is inpired by kos42 and eliottinthesky

...t fit. if you have the v1 model, you hav to put m3 screw. i made top case more larger. but the v1 model is ok, just little loose.

...ed by:https://www.thingiverse.com/thing:4642517https://www.thingiverse.com/thing:3365335https://www.thingiverse.com/thing:3622076

...using a large size heat-shrink tube to wrap the respeaker in order to better conceal it behind the mesh...

...housing for snips. suitable for: raspberry pi 3 sd-card respeaker 2 mic arry visaton 2007 speaker the housing still...

...parts needed for this device: a raspberry pi a respeaker 2-mics pi hat a speaker like audiocore ac870 a...