Remix - 3D Printed Frame of Laser-Cut Paper Lamp - Split Interlayer by mywald

Last crawled date: 3 years, 4 months ago

I've been working on the papercut-frame this remix is based on.
Since you need 10 same interlayer frames, and I could only print 1 at a time, I've split up the model, so that I can stack many of them on my printer bed.
They are later clamped into the outer frame, so I guess you don't even have to glue them up. In my case I have a mix of 6 complete and 4 split frames, and I think it should be stiff enough for its purpose. I haven't yet put it together though. But it should also be easy to glue the two parts together.
Also there is a front-face model attached here. That is an improvement part I will print out to have a better surface for the face border. I printed the outer frame in wood filament and it does look very odd on the side that is laying downside on the bed. So the additional face will be glued upon the border to have a rough, fluffy wood feeling on the outside.