Raspberry Pi 3 Case with Homematic RPI-RF-MOD

Last crawled date: 4 years, 3 months ago

This is an easy to print case for the Raspberry Pi 3B+ and the Homematic RPI-RF-MOD
You need 3x M2.5x6mm screws
After the print, remove the integrated supports in the HDMI and Micro-USB Ports with a sharp knife.
Then insert the RPi and fix it with 2 screws to the bottom.
Install the RPI-RF-MOD and close the case with the top. insert the last M2.5x6mm screw into the square hole and secure it.
One hole at the top of the case shows the Status LED (bigger one) and the other is to press the reset button with a needle or similar small and thin piece.
I designed a clickable insert for this square hole so you can make your own "stickers" on it. (or use the raspberry in the example). For this please use the Nupsi.step as a start.