Pi ZeroW exterior frame mount for Prusa MK3 by Bigdogbro1

Last crawled date: 3 years, 1 month ago

For externally mounting the Raspberry Pi Zero W board to the rear of the Einsy enclosure of a Prusa i3 MK3 3D printer. Printed in PLA. This is a dimensional part so your printer must be setup to print accurately. Must remove four vent crossbars on the enclosure. You will need two 3mm x 8mm long phillips flat head screws and two 3mm hex nuts OR two #4-40 x 5/16" long phillips flat head screws and two #4-40 hex nuts. The nut carriers go inside behind the venting slots to hold the frame against the enclosure. The extension header just plugs into the backside of the Einsy board. You will need to remove the two end pins from the 16 pin Digikey connector header for it to plug into the 14 pin Einsy connector.
Print the cover smooth face down and the frame pegs facing upward. Print the nut holders with the hex nut cavity facing upward.
USE AT YOUR OWN RISK! DOUBLE CHECK ON THE PRUSA FORUM FOR ANY ELECTRICAL CONNECTION CHANGES BEFORE PLUGGING IN THE Pi ZERO.
Must purchase a pin extension (header connector) from Digikey https://www.digikey.com/products/en?mpart=ESQ-108-14-G-D&v=612
See this post for more information:https://shop.prusa3d.com/forum/original-prusa-i3-mk3-f30/raspberry-pi-zero-external-mount-frame-t12551.html#p56488
Good luck, Enjoy!