Homematic Table / Desk Stand Tischaufsteller by conny_g

Last crawled date: 3 years, 1 month ago

Table / desk / shelf stand for Homematic & Homematic IP thermostats.
The first print (photos) even printed great as is, without leaning it and without supports.
Currently trying printing it 15 degrees leaning backwards with supports only from build plate to make the upper overhang even easier. See photos.
Result of these tests: that leaning works well with special support material (breakaway or water soluble) but not well with the same material.
For best quality print with 3 perimeters, 1mm top/bottom, seam on the backside right or left, 0.1mm layers, <= 40mm/s speed, <= 25mm/s for outer walls and top/bottom, 25% infill.
In this quality it prints in 17 hours and needs 70g of material.
Print the 2 clamps separately and glue them in with superglue or plastics glue.
Make sure they are oriented correctly, the "fin" should point outwards (see zoom photo).
Outside of that and the usual fine-tunings with sandpaper (3 minutes), no post processing required.