Holden Commodore Map Seat Clip by tezza98

Last crawled date: 3 years, 1 month ago

This is a customised clip for the map pocket for a VZ, VY etc Holden Commodore.
If you need a clip like the one in the pictures, then this is for you
You need to print both of the files, the left one and the right one.
I decided to design and print these instead of spending at least $20 for replacement clips
Print both the parts on their sides, and slot into the respective spots on your seat map pocket.
Designed in Fusion 360, these are version 9, after much trial and error. There is a left side and a right side because i needed to add strength to the parts, and where they slot in necessitates a left and right version where the strengthing part is on the respective sides.
I printed in ABS at 0.2mm height, 20% infill
just a little note, that they are a bit tight when you go to put the map seat back into the seat itself, so its pretty much a 1 shot installing them, and they will most likely break if you try to remove the seat again, but again a few cents of ABS vs $20 is well worth it.