Elephant Cutlery Strainer - Support Free + 5mm higher by pdiezc

Last crawled date: 2 years, 11 months ago

Remixed the support-free cuttlery drainer with 5 mm longer legs to add clearance for the sink edge.
It still requires support for the elephant trunk, the following settings in Cura should do the trick:
'Support Placement' to 'Touching Buildplate' --> in order to add the support under the turnk but to avoid it inside the trunk or other parts like the eyes
'Support Overhang Angle' to '70 (or higher)' --> in order to make sure there's only support under the trunk, the rest of the elephant prints fine without.