doge coin usb wallet by rillima04

Last crawled date: 3 years, 1 month ago

Assembly steps:
1) Print out all parts, i would strongly advise the recommended print setting
2) Remove all support material
3) If you want to, feel free to paint it (look into type of paint to use and material) i would advise you to do this before you put in the drive
4) Remove the case from your usb drive, i recommend these drives (i also recommend installing your wallet after incase you damage the drive)
5) Place the usb in the side with the larger hole, the side of the coin doesn’t matter(unless you want a specific side up when plugged in)
6) Epoxy or glue the usb drive in place and then 2 halves with the same shape hole together
7) If necessary, further remove excess material from the interlocking holes and the usb hole if the parts don’t fit together
8) Install your wallet of choice on the drive, I recommend multidoge
Notes : you may need to use a usb extender to connect it to some computers
ignore the usb header in pictures its just a place holder and I modeled it to large
this designed should work with most standard sized usb pcbs
I would advise printing the inside faces of the coin as the bottom because it doesn't matter how that looks
If you print the coin without the space for a usb drive, feel free to lower the infill and again print with the inside facing down
This is totally free to use but if you feel like it you can tip me some dogecoin or bitcoin at:
doge: DTGkWJhsYTtQxG6JoMjQFN3nGPJuRyFxY1
bitcoin: 1ATUKU4DVZwFudwcRpp8My99rrnAdtt6Jp