Dell Wyse 5070 Stand by examiner

Last crawled date: 3 years, 4 months ago

This is a stand for a Dell Wyse 5070 that uses the existing mounts in the case.
Variations
There are three different variations: minimal, large, and mesh.

Minimal: is about the width of a slim 5070 with 4 wings and works well for the slim 5070.


Large: is very close in shape and style to the OEM stand.

Mesh: is like the large except that it has a mesh inset that looks like the 5070's textured surface.
The length of each stand is about the length of the 5070 (about 20cm), with minimal being about a centimeter shorter than the large.
Source
I've included Openscad source files if you want to modify the build.
The latest source is also available on github.
Infill
I used a Creality Ender 3 Pro to build with a layer height of 0.20mm. Because the models are quite large, you may wish to do selective infill with structural areas set to high infill and non-structural much lower
The way to do this varies according to your slicing software. In Cura, you load a stand from wyse-stand-XXX.stl and the infill model from wyse-stand-infill.stl. Turn off Ensure Models are kept apart in settings. Select the wyse-stand-infill model, and then use the Per Model Settings and set that model to Mesh Type: modify settings for overlap. Choose Select Settings and modify infill to something close to 100%. Then all you have to do is align the two models to overlap the same positions on the build platform. Z-axis setting should be 0 for both; one of X or Y should be zero depending on rotation. Use the overhead view and align the modelson the other axis. It should be plus or minus a few millimeters. And then you're set.
After a millimeter or two of base, you should be able to see the difference in infill if you've done it correctly.