3D LabPrint Focke-Wulf Ta 152 C - WingMod for better belly landings by Airc-Pirates

Last crawled date: 3 years, 1 month ago

The Focke-Wulf Ta 152 from 3dlabprint.com is a blast to fly, but belly landings are terrible because the aileron control horns can break. Of course, you can print new ailerons with new control horns, but that doesn't solve the problem. Just flip the ailerons over so that the control horns are protected on the top of the wing and modify the wing with this part.
WingMod - HowTo (steps for each servo of the wing):
mark the center position of the servo horn inside the servo hole
mark a rectangle 15mm x 5 mm around the center position of the control horn for the movement area
drill four small holes (max. 2mm each) through the wing at the corners of the rectangle
cut out the rectangle
glue the WingModPart into the hole of the rectangle
That's it.
Now the wing is ready for better belly landings.
Have fun!