1U Quarter-rack Shelf by cmclernon

Last crawled date: 3 years, 1 month ago

This is a remix of the "1U Half-rack Shelf (1 Post)" by rqdsvw (https://www.thingiverse.com/thing:2114676) .
I used MeshMixer to cut the model in half, then exported to STL.
I found I couldn't fit the half rack on my print bed and decided I only needed a quarter width for my raspberry pi and relay setup. You could throw a cable tie through the vent holes to secure anything in place.
One thing to note is that the plastic wings are thicker than a traditional metal rack mount appliance so you will need screws that are on the longer side to thread into your rack nuts.
Works well at 25% infill for the weight I was putting on it.