Split Keyboard by MrAnderson6655

Last crawled date: 3 years, 1 month ago

This is a split keyboard based on technomancy's Atreus.
Info about the Atreus can be found here: https://atreus.technomancy.us/
The keyboard uses firmware built by reddit user _spindle which is a branch of TMK and can be found here: https://github.com/ahtn/tmk_keyboard/tree/master/keyboard/split_keyboard
Completed pictures and build pictures can be found here:https://www.reddit.com/r/MechanicalKeyboards/comments/4q0g4e/fully_3d_printed_split_atreus/
The hardware used is as follows:
42 Cherry style or Matias switches
42 1N4148 Diodes
2 Arduino Pro Micros (mine are from Ebay)
4 USB Micro B Breakout Boards (mine are from Adafruit)
3 USB Micro B male connectors
1 USB A male connector
4 6mm M2 standoffs
8 M2 screws to fasten the USB breakouts to the standoffs. My screws were slightly too long so I used a nut as a washer
16 16mm M2 screws to fasten the plate to the case
16 M2 nuts to fasten the case to the plate
30AWG color coded wire
30AWG magnet wire
1 3D Printed left plate
1 3D Printed left case
1 3D Printed right plate
1 3D Printed right case
40 1u keycaps (I used DSA)
2 1.5u keycaps
NOTE: The housing space for the Pro Micro is inspired by this thinghttp://www.thingiverse.com/thing:320421
It is intended for some small cuts to be made to free the tab that holds the controller in place with a snap fit.