Elecraft KX3 Stand and Battery Holder

Last crawled date: 4 years, 3 months ago

Elecraft KX3 Stand
Smaller Lighter
Another KX3 stand. Smaller (I think? I've not actually measured it or compared the two) and lighter than my previous one. This one isn't split down the middle, instead it uses an 'end cap' with integral pegs to hold it in place. It also takes a lot less time to print! :)
You hang the KX3 on this one by pushing the legs into the cut-outs. Ideal for portable use. Seems to be more stable even without a battery.
I have included two versions of the end cap, a plain cap and one with a hole for wires and an internal slot for a BMS / charger board.
Files
All files included, created with FreeCAD.
Dimensions
Sorry, I don't know. Either load into FreeCAD, or some other compatible software and measure it there, or print it and measure it.